Tagsys S.A. LSP3CLEAR-L40 User Manual
40/68
Revision 2.1
December 2009
5.4.3 TCP/IP Configuration and Firmware Upgrade
Figure 19: TCP/IP Configuration and Firmware Upgrade Tab
This tab is used either:
•
To upgrade System Firmware.
•
To upgrade Radio Firmware.
•
To modify TCP/IP Configuration, including port.
Upgrading System Firmware
Click “System Upgrade”, and then select the appropriate firmware file. A bar shows the progress of
the upgrade process. After upgrade is completed, you can decide to run the new firmware
immediately by rebooting the pedestal, or to wait for next reboot to run it.
the upgrade process. After upgrade is completed, you can decide to run the new firmware
immediately by rebooting the pedestal, or to wait for next reboot to run it.
Upgrading Radio Firmware
Click “Radio Upgrade”, and then select the appropriate firmware file. A bar shows the progress of
the upgrade process. After upgrade is completed, you can decide to run the new firmware
immediately by rebooting the pedestal, or to wait for next reboot to run it.
the upgrade process. After upgrade is completed, you can decide to run the new firmware
immediately by rebooting the pedestal, or to wait for next reboot to run it.
It is possible to revert to the default settings (DHCP active, fallback IP
address set to 169.154.0.100). To do so, power-off pedestal, press and
hold the LCD button, power-on pedestal, wait 5s then release LCD
button.
address set to 169.154.0.100). To do so, power-off pedestal, press and
hold the LCD button, power-on pedestal, wait 5s then release LCD
button.