Tagsys S.A. LSP3STANDARD User Manual
Library Security Pedestal 3
50/63
Revision 0.2
May 2009
In “Antennas and Power” section:
•
Select the RF output power. The output power can be lowered to avoid disturbing nearby
RFID systems (in such a case, check system performance). The output power can be
increased, but only to carry on tests.
RFID systems (in such a case, check system performance). The output power can be
increased, but only to carry on tests.
•
Select antenna sequence used when scanning the pedestal. Select “Top>Center>Bottom”
for standard operation or specifically an antenna for diagnosis operations (Top, Center or
Bottom).
for standard operation or specifically an antenna for diagnosis operations (Top, Center or
Bottom).
In “Region” section, select the EMC regulations applicable to your region (FCC or ETSI).
5.5 People Counter & Buzzer Sound Management
5.5.1 Resetting the Counter Display
Figure 28: People Counter & Detection Cells Location
To reset the LCD display use a pointed element (for example: a paper clip). Insert it in the hole on
the right of the display window and press (not too hard) until you get zero displayed. This will also
reset the battery backed-up counter.
the right of the display window and press (not too hard) until you get zero displayed. This will also
reset the battery backed-up counter.
In any case, for operational configuration output power should not
exceed 4W to remain compliant with Radio Regulations.
exceed 4W to remain compliant with Radio Regulations.
Buzzer Level Adjust
LCD Counter Display
Counter Reset Button