Tagsys S.A. MEDIOL40 User Manual
Medio L40 - User's Guide
20/56
Revision 2.3
July 2013
3.3.2 Rear Panel
The rear panel is dedicated to the power supply and communication connectors.
Figure 2: Rear panel
•
10/ 100 Ethernet Connector
RJ 45 connector (Please refer to the Ethernet network cabling rules).
•
USB Connector
USB connector type B. Use standard A/B cable to connect to the host (not included in the
package).
package).
•
RS-232 Connector
RS232 protocol has been implemented through a RJ 45 connector. A RJ45 to DB9 adapter is
needed to connect to the host. Please see section
needed to connect to the host. Please see section
6.2 RS232 Interface
for more details.
•
GPIO connector:
A Male connector on the reader’s rear panel implements 2 digital inputs/outputs (N-Channel Open
Drain). Please see section
Drain). Please see section
6.3 GPIO Connector
for more details.
•
24VDC Connector
A power supply connector. Please see section
4.2
Cabling
Requirements
for more details
•
Synchronization Connector
For TAGSYS Internal use only.
•
Reset Button
This button allows restoring the reader to its factory settings. Please see section
0
Restoring
Factory Configuration
for more details.