CommScope Technologies LLC 800002 User Manual
98
Airvana Confidential & Proprietary, 910011: June 28, 2002
Understanding the antenna installation process
This process explains all steps and procedures to follow when connecting RF and GPS antenna cables.
1.
Understanding cautions and warnings
Understand and follow all warnings and cautions or injury, death, or damage to equipment can occur.
See
2.
Understanding the Rox System
This section explains the pre-assembled configuration in which the Rox System ships.
See
You can optionally assemble your own Rox System.
See
3.
Removing access panels
Remove the antenna access panel in order to install the Rox System cabinet seal. You must also remove
the surge protection access panel in order to connect Rox System antenna cables internally to the surge
protection bar.
the surge protection access panel in order to connect Rox System antenna cables internally to the surge
protection bar.
See
4.
Installing the Rox System cabinet seal
The Rox System cabinet seal must be installed into the cabinet opening created when you remove the
antenna access panel on the top back of the cabinet. Installation involves routing the cables into the
cabinet and screwing the Rox System cabinet seal into place.
antenna access panel on the top back of the cabinet. Installation involves routing the cables into the
cabinet and screwing the Rox System cabinet seal into place.
See
5.
Connecting GPS and RF antennas
All antenna cables routed through the Rox System cabinet seal must be connected to the surge
protection bar on the inside of the cabinet and to external antenna cables/surge protection equipment on
the outside of the cabinet. The surge protection access panel must be re-installed.
protection bar on the inside of the cabinet and to external antenna cables/surge protection equipment on
the outside of the cabinet. The surge protection access panel must be re-installed.
See
This process is complete. You must install modules. Go to
Understanding the module installation process
on
page 116.