Falcom GmbH FOX User Manual

Page of 31
FOX H
ARDWARE
 M
ANUAL
                      - P
RELIMINARY
 -
V
ERSION
 1.0.0
9 APPENDIX
9.1 Schematics
The figure below illustrates a common schematic when you use the FOX hardware 
for   vehicle   security.   For   detailed   information,   please,   refer   to   the   related 
documents [
].
9.1.1 Installation guidance for 8-wire cable connector
 
 
On the top of the schematic you can find the corresponding pin out of the 8-pin 
connector.
When installing your FOX  in a vehicle, you will not only be able to track and locate the 
vehicle all the time, but also you will be  automatically  notified when disagreements 
with your configuration loaded into the FOX device occur. Furthermore, the firmware-
controlled outputs allow you to lock/unlock doors etc. While the IGN input line can be 
used to monitor the vehicle ignition key, two other inputs can be  used as digital  or 
analog and may be individualized for each customer.
Note that, the output of the FOX and +IN must connected on the same voltage  level as  
the supply voltage +IN operates.
The   operating   voltage   range  MUST  never   be   exceeded.   For   security   reason,   it   is  
recommended to integrate externally a 2A fuse link between the positive wire of the 
FOX (+IN) and d.c. - power source. 
Please note that, the ground pin of the FOX unit should be isolated  from the  
vehicle body to avoid ground loops.
 
Figure 14:
Schematic example of installation guidance.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 30 of 31