Manualsbrain.com
  1. Manuals
  2. Brands
  3. AeroComm Corporation
  4. PKLR2400-200
  5. User Manual

AeroComm Corporation PKLR2400-200 User Manual

Download
Page of 57
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications               
               
               
                                               
                                
                                
                                                        
                        
                        
                            
11/24/03
29
5.2.4
5.2.4
5.2.4
5.2.4  Received Data
Received Data
Received Data
Received Data
A transceiver issues this command upon reception of data from the RF interface.  The information in
the data frame is the received data.
Since more than one Client can transmit to a Server, multiple 
Received Data 
Received Data 
Received Data 
Received Data commands can be issued
to the Server Host at the same time.  The command does not require an 
Acknowledge
Acknowledge
Acknowledge
Acknowledge command;
therefore, the Server Host must be capable of receiving multiple, consecutive 
Received Data
Received Data
Received Data
Received Data
commands.
Data Frame:
83h
Length Low
Length High
Data
Checksum
Destination
Destination
Destination
Destination
Address
Address
Address
Address
Source Address
Source Address
Source Address
Source Address
Data
Data
Data
Data
MS Byte…LS Byte
MS Byte…LS Byte
5.2.5
5.2.5
5.2.5
5.2.5  In Range
In Range
In Range
In Range
The Client issues this command upon detecting a Server beacon after a Reset or after an 
Out of Range
Out of Range
Out of Range
Out of Range
command has been issued to the Host.  The Client Host will get updated with this command at the
time intervals specified by the Range Refresh parameter at EEPROM address 32h.  The OEM should
allow for some hysterisis so the Host isn’t flooded with these commands in a fringe coverage area.
AeroComm has established a default value of 5 seconds through extensive testing.  This command
includes the IEEE 802.3 Server Address.
Data Frame:
84h
06h
00h
Data
Checksum
Server IEEE  Address
Server IEEE  Address
Server IEEE  Address
Server IEEE  Address
MS Byte…LS Byte
5.2.6
5.2.6
5.2.6
5.2.6  Out of Range
Out of Range
Out of Range
Out of Range
The Client issues this command if it does not detect a Server beacon after a Reset or after an 
In Range
In Range
In Range
In Range
command has been issued to the Host.  The Client Host will get updated with these commands at the
time intervals specified by the Range Refresh parameter at EEPROM address 32h.  The OEM should
allow for some hysterisis so the Host isn’t flooded with these commands in a fringe coverage area.
AeroComm has established a default value of 5 seconds through extensive testing.