AeroComm Corporation PKLR2400-200 User Manual
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
11/24/03
31
6.2.1
6.2.1
6.2.1
6.2.1 Enter Command Mode
Enter Command Mode
Enter Command Mode
Enter Command Mode
Prior to sending any other AT command, the radio must be sent the Enter Command Mode command
by the OEM Host. Below is a description of that command:
by the OEM Host. Below is a description of that command:
AT+++
↵
Where
↵
is equal to 0DH (13 decimal).
If it is unable to successfully receive the command, the radio will interpret the string as a packet to send
out over the RF and will act accordingly. Upon successfully receiving the Enter Command Mode
command, the radio will be ready to receive other AT commands and will issue the following response
to the OEM Host:
out over the RF and will act accordingly. Upon successfully receiving the Enter Command Mode
command, the radio will be ready to receive other AT commands and will issue the following response
to the OEM Host:
OK
↵
Where
↵
is equal to 0DH (13 decimal).
After successfully receiving the Enter Command Mode command, the radio will not be able to
communicate with other radios until AT command mode is exited. If a server is commanded into AT
mode, the clients will go out of range.
communicate with other radios until AT command mode is exited. If a server is commanded into AT
mode, the clients will go out of range.
6.2.2
6.2.2
6.2.2
6.2.2 Exit Command Mode
Exit Command Mode
Exit Command Mode
Exit Command Mode
To exit AT mode without resetting the internal static parameters of the radio, an Exit Command Mode
command should be sent to the radio by the OEM Host. Below is a description of that command:
command should be sent to the radio by the OEM Host. Below is a description of that command:
ATO
↵
Where
↵
is equal to 0DH (13 decimal).
If it successfully receives the command, the radio will issue the following response to the OEM Host:
OK
↵
Where
↵
is equal to 0DH (13 decimal).
If it is at least able to receive the
↵
character but there is an error in the command or part of the
command is missing, the radio will issue the following response to the OEM Host:
ERROR
↵
Where
↵
is equal to 0DH (13 decimal).
Upon successfully receiving the Exit Command Mode command, the radio will resume RF
communications.
communications.