AeroComm Corporation PKLR2400-200 User Manual
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
11/24/03
32
6.2.3
6.2.3
6.2.3
6.2.3 Power-on Reset Command
Power-on Reset Command
Power-on Reset Command
Power-on Reset Command
To force the radio to perform a Power-on Reset, the Power-on Reset command should be sent to the
radio by the OEM Host. Below is a description of that command:
radio by the OEM Host. Below is a description of that command:
ATZ
↵
Where
↵
is equal to 0DH (13 decimal).
If it successfully receives the command, the radio will issue the following response to the OEM Host:
OK
↵
Where
↵
is equal to 0DH (13 decimal).
If it is at least able to receive the
↵
character but there is an error in the command or part of the
command is missing, the radio will issue the following response to the OEM Host:
ERROR
↵
Where
↵
is equal to 0DH (13 decimal).
Upon successfully receiving the Power-on Reset Command, the radio will perform a power-on reset
and resume RF communications.
and resume RF communications.
6.2.4
6.2.4
6.2.4
6.2.4 Read IRAM Byte
Read IRAM Byte
Read IRAM Byte
Read IRAM Byte
IRAM Reads are performed one byte at a time. To read a byte of IRAM, the OEM Host should issue
the following command to the radio:
the following command to the radio:
ATSXX?
↵
Where XX is equal to an IRAM address. If the address is less than 10H, the leading zero must still be
sent such as ATS05?
sent such as ATS05?
↵
Where
↵
is equal to 0DH (13 decimal).
If it successfully receives the command, the radio will issue the following response to the OEM Host:
YY
↵
Where YY is equal to the value of the IRAM location requested.
Where
↵
is equal to 0DH (13 decimal).
If it is at least able to receive the
↵
character but there is an error in the command or part of the
command is missing, the radio will issue the following response to the OEM Host:
ERROR
↵
Where
↵
is equal to 0DH (13 decimal).