Hunter Industries Inc SSW User Manual

After.Solar.Sync.has.been.installed.and.programmed,.it.is.recommended.to.allow.the.system.to.run.for.a.few.days.at.the.initial.setting..

Because.of.the.variety.in.site.conditions.(including.sensor.location,.amount.of.direct.sunlight.available.to.the.sensor,.reflective.heat.from.

surrounding.structures,.etc),.the initial setting may require adjustment in order to arrive at the desired performance..The.calibration.of.the.

Solar.Sync.to.a.particular.site.can.easily.be.accomplished.by.adjusting.the.Region.and/or.Water.Adjustment.settings..The.instructions.below.

outline.this.process:
1.. Install.Solar.Sync.sensor.and.program.the.module.(as.described.in.pages.10–12)
2.. Allow.system.to.operate.at.initial.settings.for.a.minimum.of.3.days
3.. .Observe.the.Seasonal.Adjust.on.the.controller..If.the.Seasonal.Adjust.amount.appears.to.be.lower.or.higher.than.expected.for.that.time.

of.year,.the.Solar.Sync.settings.need.to.be.adjusted..

.

.

a.   Seasonal Adjust too low: Make.sure.controller.dial.is.in.the.“Run”.position..Increase.the.value.on.the.Water.Adjustment.scale.(10.is.max)..

Once.the.setting.is.changed,.the.controller.will.immediately.be.updated.with.the.new.Seasonal.Adjust.%..Increase.the.Water..

Adjustment.setting.until.the.desired.Seasonal.Adjust.%.is.shown..If you max out the Water Adjustment scale at 10 and still require 

.

.

b.  Seasonal Adjust too high:.Make.sure.controller.dial.is.in.the.“Run”.position..Decrease.the.value.on.the.Water.Adjustment.scale.(default.

setting.is.5)..Once.the.setting.is.changed,.the.controller.will.immediately.be.updated.with.the.new.Seasonal.Adjust.%..Decrease.the.

Water.Adjustment.setting.until.the.desired.Seasonal.Adjust.%.is.shown..If you minimize the Water Adjustment scale down to 1 and still 

Station run Times:.It.is.important.to.understand.that.Solar.Sync.provides.a.global.seasonal.adjustment.to.the.controller..This.means.that.

all.station.run.times.will.be.modified.by.the.seasonal.adjust.percentage.shown..When.programming.the.controller,.the.run.times.should.be.

entered.that.represent.peak.season.watering.schedules..If.the.Solar.Sync.is.adjusting.to.the.appropriate.seasonal.adjust.value.but.the.run.

time.for.a.particular.station.appears.to.be.too.long/short,.adjust.the.station.run.time.in.the.controller.program..When adjusting station run