Bendix Commercial Vehicle Systems LLC TX433VM User Manual
SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/20/2000 Page 24 of 56
This manual is under review by SmarTire – DO NOT ISSUE
Receiver
Operation
Ensure the receiver is plugged in. After power is applied the lights flash red, green, then amber.
They continue to flash amber until signals are received from the tire transmitters which transmit
pressure data shortly after the vehicle starts to move (at speeds greater than 10kph).. Then all will
turn off except the system light (left most light).
The receiver is preset to initiate warnings at two levels of tire pressure. Typical settings are 24
PSI to initiate a Low Pressure Alert and 18 PSI to initiate a Low Pressure Warning. Check
your kit documentation for the settings for your receiver.
They continue to flash amber until signals are received from the tire transmitters which transmit
pressure data shortly after the vehicle starts to move (at speeds greater than 10kph).. Then all will
turn off except the system light (left most light).
The receiver is preset to initiate warnings at two levels of tire pressure. Typical settings are 24
PSI to initiate a Low Pressure Alert and 18 PSI to initiate a Low Pressure Warning. Check
your kit documentation for the settings for your receiver.
When transmissions are received amber tire lights
turn off one at a time and finally system led turns
green and stays on steady.
turn off one at a time and finally system led turns
green and stays on steady.
System light is on green. Normal condition with no
alerts on any tire.
alerts on any tire.
On Low Pressure Alert, there is a long beep, the
tire light turns red and stays red.
On Low Pressure Warning, the receiver beeps five
times, with accompanying red light. Then red light
flashes. After one minute receiver beeps five times.
Continues until tire condition is corrected. Then light
turns off.
tire light turns red and stays red.
On Low Pressure Warning, the receiver beeps five
times, with accompanying red light. Then red light
flashes. After one minute receiver beeps five times.
Continues until tire condition is corrected. Then light
turns off.
Programming the Receiver
The factory settings for Low Pressure Alert and Low Pressure Warning can be changed with the
multi-function display. When a new transmitter is installed its ID must be programmed into the
receiver for it to be able to receive data. This is done with the Learn Mode of the multi-function
display.
multi-function display. When a new transmitter is installed its ID must be programmed into the
receiver for it to be able to receive data. This is done with the Learn Mode of the multi-function
display.