Humax C41-500 User Manual

107

    Check the HD output resolutions and deselect those not supported by your TV. For 1080p programs, some TVs do not 

support the 24 frame-per-second rate DIRECTV provides. Press the RES button on your receiver’s front panel to change the 
resolution to one your TV supports.

Possible Causes:

   Weak batteries are almost always the problem.
   Trying to operate equipment other than your DIRECTV Receiver?
   Remote sensor on the receiver could be blocked.

Solution:

   Check that nothing is between the remote control and the remote 

sensor.

   Make sure the remote control is in DIRECTV mode. Slide the MODE 

switch on the remote to the DIRECTV position so the remote will control the DIRECTV

®

 Receiver.

   Check the batteries in the remote control. They may be weak, dead 

or installed incorrectly. Try replacing batteries. 

   If you’re entering a channel number that is less than four digits long, 

the receiver might wait two seconds before tuning to the channel. 

Press ENTER after entering a channel number to tune immediately.

   If you are trying to operate a device other than the DIRECTV DVR 

that you have programmed the remote to control, make sure you 

first slide the MODE switch to the mode that is programmed for that 

device (AV1 or AV2). The indicator light for the component you’re 

trying to control should light up when you press a valid key for that component. If it doesn’t, make sure the MODE switch is in 

the correct position.

CHAPTER

 8

 -

 TROUBLESHOOTING

 &

 FAQS