Humax F2-1003 User Manual
8. Installation
50
①
Select Search, and press the <OK> button to start
Automatic Search.
②
During operating search, the cursor is located at
Stop. Therefore, if you press the <OK> button during
searching, the operation is stop and the channels
found until then will be displayed.
③
Even if search operation is completed, and the
channel does not exist, press the <OK> button and
try to reset the search operation again if necessary.
④
You can delete unnecessary channels from the
searched channels. Select your desired channels to
delete and press the <OK> button. Then select Delete
and press the <OK> button. To delete all channels,
select Select All to select all channels, select Delete,
and press the <OK> button.
⑤
When completing Channel Search and deleting
unnecessary channels, select Save to save the
changes.
8.3 Manual Search
You can search channels of the selected satellites by transponders if you know the
Transponder information.
(1) Satellite
Selects a satellite to search from the satellites set in Antenna setting.
①
Select Satellite using the ▲▼ button, and press the
<OK> or <Right> button.
②
Select one of the Satellite names to search channel
using the ▲▼ button, press the <OK> button.
[Note]
If the satellite scheduled to search channel is not exist in the
Satellite list, move to Antenna Setting menu, set Antenna for
the Satellite, and then try again.
(2) Transponder
Sets transponder value for the satellite.