Adtran 1700412E11 User Manual

 Unit Installation

NetVanta 150 Wireless Access Point ABG Hardware Installation Guide

 24

Copyright © 2006 ADTRAN, Inc.

61700412E1-34A

The NetVanta 150 unit can be powered either by the LAN Ethernet connection or through the 12 VDC 
external supply. The Wall Supply is not included in shipment of this unit but can be requested from Adtran 
or your reseller. See Product Support Information on page 9 for more information on contacting Adtran.

1. Connect the NetVanta 150 unit to the PC using the 

 port on the back of the unit and  the 

appropriate Ethernet cable.

2. Supply power to the PC and the NetVanta 150 unit and begin the operating system boot up process. 

During boot up, the PC will obtain an IP address from the NetVanta 150 unit DHCP server. By 
default, both the DHCP and HTTP servers are enabled. The default IP address is 10.10.10.1.

3. Enter the unit’s IP address in your browser address line. The default IP address is 

.

4. You will then be prompted for the username and password (the default settings are 

 and 

).

5. The initial GUI screen appears.

6. Click on 

 in the 

 menu on the left side of your screen and follow the 

on-line instructions.

•

If the factory default switch is pressed during bootup, the unit will stay in bootstrap mode. Since the unit 
has no serial port, Telnet has been built into the boot code. The default IP address is 10.10.10.1.

•

If the factory default switch is pressed and held for 5 seconds after boot, the 

 interface on the 

NetVanta 150 will default to 10.10.10.1 and all access policies will be removed from that interface.

•

If the factory default switch is pressed for 30 seconds, a default configuration will overwrite your 
existing configuration and reboot the unit.