JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 22
Once the battery pack is installed, replace the promo insert and the lens cover.
After installing the replacement battery pack, the charge indicator should be
visible. Charge the pager for at least 2 hours. If the promo key was removed
from the bungee cord hanging on the charger, return it to that clasp so that it will
be available the next time that it is required.
After installing the replacement battery pack, the charge indicator should be
visible. Charge the pager for at least 2 hours. If the promo key was removed
from the bungee cord hanging on the charger, return it to that clasp so that it will
be available the next time that it is required.
NOTE: As a consumable item, the standard warranty on the rechargeable NiMH battery pack is
90-days. If a battery-related failure is experienced during this time, simply contact JTECH
Customer Care for a replacement. Outside of the 90-day warranty period, JTECH offers a
replacement NiMH battery pack at a nominal charge, which can be ordered with part number
232020.
90-days. If a battery-related failure is experienced during this time, simply contact JTECH
Customer Care for a replacement. Outside of the 90-day warranty period, JTECH offers a
replacement NiMH battery pack at a nominal charge, which can be ordered with part number
232020.
Promo Insert Installation
Listed below are the steps depicting the process of inserting a new promo insert
into the CommPass promo area:
1. Insert key into latch area at top of CommPass pager, releasing the lens.
2. Open the promo lens area by first sliding the lens “down” in the direction of
2. Open the promo lens area by first sliding the lens “down” in the direction of
the base, and then rotating the lens away from the pager housing.
3. Remove, replace and secure the promo insert (Fig. 16).
4. To re-attach the lens, re-position the tabs at the base of the promo lens
4. To re-attach the lens, re-position the tabs at the base of the promo lens
into the slots at the base of the CommPass pager housing, sliding the lens
“up” in the direction of the “top” of the pager.
“up” in the direction of the “top” of the pager.
5. “Close” the promo lens until the tongue latches on the inside top of the
lens cover slide into the slots in the CommPass pager housing and the
unit “clicks” shut.
unit “clicks” shut.
Fig. 16 – Installing the CommPass Promo Insert
Care and Maintenance
Wipe CommPass pagers with a soft cloth moistened with mild soap and water.
Never spray liquids (cleaning solution or water) directly on the pagers.
Wipe CommPass pagers with a soft cloth moistened with mild soap and water.
Never spray liquids (cleaning solution or water) directly on the pagers.
“base”
“top”