JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 24
Paging from the Desktop Transmitter
To send a page to a vibe/tone, Glowster or CommPass pager
Enter the pager number (up to four digits) followed by the # key. A display
including the pager number and ‘Snt’ will appear in the display indicating the
page has been sent. The red ‘TX’ light above the keypad illuminates, indicating
the Desktop Transmitter is transmitting the page.
To send a page to a single numeric pager
Enter the pager number (up to 4 digits) followed by the * key. Enter an optional
message of up to sixteen digits followed by the # key. If no message is desired,
simply press the # key after the * key. ‘Num’, the pager number and ‘Snt’ will
appear in the display indicating the page has been sent. The red ‘TX’ lamp
illuminates indicating the page is being transmitted.
To send a message to a factory programmed and/or a dynamic group of
numeric pagers
Press the * key to go to enter group mode, and then enter a valid group number.
Valid group numbers are 1- 99. Enter * to indicate that the group number has
been entered and is complete. If there is a message, enter the message of up to
sixteen digits. In either case, enter the # key next. The display will indicate that
the group page has been sent and in the case of dynamic group members, it
displays the individual members as the sequential group is paged. The red ‘TX’
lamp illuminates for each transmission indicating the page is being sent. The
display will return to the ready state, which is 'Enter Pager #', after the last page.
To cancel a page before it is sent
Press the * key twice.