Wacom DTI-520 User Manual

● The following message appears 

briefly on your display screen:

■

The input signal frequency is incorrectly set or not 

compatible with the DTI-520. Connect a different display 
and set the refresh rate (vertical frequency) to some value 
between 50 and 75 Hz. If your video card driver supports 
djustment of the horizontal frequency, make sure it is set to 
some value between 30 and 80 kHz.

■

 The resolution is set too high (1280 x 1024, maximum).

■

 The refresh rate is set too high (75 Hz maximum).

■

 Set the display properties to detect plug and play monitors.

● The following message ppears 

briefly on your display screen:

● The power LED is lit orange or 

flashes orange and blue.

■

Check the video cable for bent or broken connector pins.  

  Then properly connect the video cable.
■

Your computer may be in a power management mode. 

Touch the pen tip to the display screen, move the mouse, or 
depress any key on your keyboard.

■

Verify that the graphics card is properly installed.

● The following message ppears 

briefly on your display screen:

■

Check that your computer is turned on.

■

Verify that you are using the video cable that came with 

DTI-520.

■

Check that the DTI-520 video cable is fully connected.

■

 Check the video cable and any video adaptors for bent or 

broken connector pins. Then properly connect the video 
cable and any necessary adaptors.

If you encounter problems with DTI-520 display, refer to the following tables. Your 
problem may be described here, and you can try the solution offered.
For additional information about color issues, refer to the documentation that came with 
your operating system or applications.