Proxim Wireless Corporation L49U24U50 User Manual

Parameter Tables

Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the 
Access Point. Columns used on the tables include:

• Name - Parameter, Group, or Table Name
• Type - Data type
• Value - Value range, and default value, if any
• Access = access type, R = Read Only (show), RW = Read-Write (can be “set”), W = Write Only
• CLI Parameter - Parameter name as used in the Access Point

Access Point network objects are associated with Groups. The network objects are listed below and associated 
parameters are described in the following Parameter Tables:

•

 - Access Point system information

–

 - Hardware, firmware, and software version information

•

 - IP and Network Settings

–

 - Configure the Access Point’s IP settings

•

 - Configure the Access Point as a DNS client

–

 - Enable or disable dynamic host configuration

–

 - Configure 

–

 - Monitor link status

•

 - Configure Wireless and Ethernet settings

–

•

 - Configure the WDS partnerships

–

 - Configure the SSIDs, VLANs, and security modes for each 

interface. Up to 16 SSIDs per wireless interface are supported; different security settings can be applied to each 
SSID, and a unique VLAN can be configured per SSID.

–

 - Set the speed and duplex of the Ethernet port.

–

 - Configure the Mesh network.

•

 - Control access to the AP’s management interfaces

–

 - Set read and read/write passwords

–

 - Set up the graphical web browser interface. If required, enable SSL and configure the SSL 

certificate passphrase.

–

 - Telnet Port setup

–

 - Serial Port setup

–

 - Configure RADIUS Based Management Access for HTTP and 

Telnet access.

–

 - Enable SSH and configure the host key.

–

 - Set up for file transfers; specify IP Address, file name, and file type

–

 - Configure range of IP addresses that can access the AP

–

 - Configure the Auto Configuration feature which allows an AP to be automatically 

configured by downloading a configuration file from a TFTP server during boot up.

•

–

 - Control network traffic based on protocol type

–

 - Enable and disable specific addresses

–

 - Enable or disable proxy ARP for wireless clients

–

 - Control which ARP messages are sent to wireless clients based on IP settings