Senstar Corporation E7BA0300 User Manual
FlexZone Wireless Gate Sensor
Page 1
FlexZone™
Instruction sheet #6
G6DA0603-001, Rev A
December 15, 2015
Description
The Wireless Gate Sensor (WGS) operates in conjunction with the FlexZone processor to provide
RF-based wireless security protection for gates. The WGS is comprised of two components. The
wireless gate sensor module (GSM) a high-sensitivity accelerometer, is attached to the protected
gate. The GSM analyzes signals picked up from the fence fabric on the gate and will transmit an
alarm when it detects vibration, motion, or positional changes. A wireless gate sensor receiver
(GSR) that is mounted on the FlexZone processor receives the transmission and passes on the
alarm signal to the FlexZone processor. Alarm data communications are via the FlexZone
processor over the Silver Network or by contact closures.
RF-based wireless security protection for gates. The WGS is comprised of two components. The
wireless gate sensor module (GSM) a high-sensitivity accelerometer, is attached to the protected
gate. The GSM analyzes signals picked up from the fence fabric on the gate and will transmit an
alarm when it detects vibration, motion, or positional changes. A wireless gate sensor receiver
(GSR) that is mounted on the FlexZone processor receives the transmission and passes on the
alarm signal to the FlexZone processor. Alarm data communications are via the FlexZone
processor over the Silver Network or by contact closures.
Features
•
300 m (984 ft.) (nominal) transmission range with the supplied rubber whip antenna (requires
direct line of sight)
direct line of sight)
•
secure RF transmissions via 128-bit encryption
•
supervised comm-link (heartbeat monitor, 2 missed transmissions = supervision alarm)
Note
Setup and operation of the WGS requires as a minimum, Network Manager
version 2.20, UCM version 1.37 and FlexZone version 2.4 software.
version 2.20, UCM version 1.37 and FlexZone version 2.4 software.
Figure 1 FlexZone Wireless Gate Sensor Module (solar powered)
solar powered GSM mounted on sliding gate
stainless steel cable ties (2 per side)
no connection to
auxiliary security device
Wireless Gate Sensor