Senstar Corporation E7BA0300 User Manual
WGS Configuration
Rev A
Senstar Corporation website: www.senstar.com email: info@senstar.com
FlexZone, Senstar and the Senstar logo are registered trademarks of Senstar Corporation. Product names and Company names included in this
document are used only for identification purposes, and are the property of, and may be trademarks of their respective owners. Copyright © 2015,
Senstar Corporation. All rights reserved. The information in this document is subject to change without notice. Printed in Canada.
document are used only for identification purposes, and are the property of, and may be trademarks of their respective owners. Copyright © 2015,
Senstar Corporation. All rights reserved. The information in this document is subject to change without notice. Printed in Canada.
6.
Select the Record button and have the tap tester begin the tests at the farthest point on the
gate from the GSM.
gate from the GSM.
7.
Continue the tap testing moving closer to the GSM and then away from the GSM on the
opposite side until the gate has been fully tested.
opposite side until the gate has been fully tested.
•
Each series of 3 taps should cause an alarm.
•
The tap tests that are farthest away from the GSM should have the lowest magnitude
response. If tests closer to the GSM have lower magnitudes, inspect the fence for loose
fabric or other issues.
response. If tests closer to the GSM have lower magnitudes, inspect the fence for loose
fabric or other issues.
•
If any of the test taps do not cause a response above the Event Threshold, repeat the
tests at that location.
tests at that location.
•
If the repeated tests remain below the Event Threshold, lower the Event Threshold and
repeat the tests.
repeat the tests.
•
If all of the tests are significantly above the Event Threshold, raise the Event Threshold
and repeat the tests.
and repeat the tests.
•
Continue this process until each series of 3 taps causes an alarm.
You can adjust the GSM detection parameters to meet your site-specific security requirements.
Once the sensor is setup, calibrated and operational you should monitor the NAR to ensure
optimum settings. Minor adjustments to the Target Filters and the Event Threshold can be used to
prevent nuisance alarms caused by environmental factors and fence condition.
Once the sensor is setup, calibrated and operational you should monitor the NAR to ensure
optimum settings. Minor adjustments to the Target Filters and the Event Threshold can be used to
prevent nuisance alarms caused by environmental factors and fence condition.
Figure 16: Gate sensor module response plot window
use the slider to
display the signal
magnitude
display the signal
magnitude
select the gate
module to test
module to test
alarm bell displays
when alarm occurs
when alarm occurs
Event Threshold
(red dotted line)
(red dotted line)
recorded signal
response from tap
testing
response from tap
testing