Senstar Corporation LM100 User Manual
Installing the LM100 gateway
Senstar LM100 Product Guide
Page 31
Surface mounting
Figure 31: Post-mounting the enclosure (on the fence)
Figure 32: Surface-mounting the enclosure
1. Hold the enclosure against the fence at the specified installation location.
2. Feed the end of the stainless steel clamp through an upper flange slot, around the fence post, and back
through the second slot.
3. Insert the end of the stainless steel clamp into the gear mechanism and tighten the screw.
4. Repeat this with the second clamp on the lower flange at the bottom of the enclosure.
4. Repeat this with the second clamp on the lower flange at the bottom of the enclosure.
1. Hold the enclosure against the
2. Drill 4 holes in the mounting surface.
3. Using appropriate hardware, mount
mounting surface, and mark the
positions of the 4 mounting holes.
positions of the 4 mounting holes.
the enclosure.
Use 7 mm (¼ in.) hardware.
Use 7 mm (¼ in.) hardware.