ZyXEL Communications Corporation G210H User Manual
ZyXEL G-210H User’s Guide
46
Chapter 4 Wireless Station Mode Configuration
Figure 27 Station Mode: Adapter
The following table describes the labels in this screen.
Table 11 Station Mode: Adapter
LABEL
DESCRIPTION
Adapter Setting
Transfer Rate
In most networking scenarios, the factory default Auto setting is the most efficient
and allows your G-210H to operate at the highest possible transmission (data)
rate.
If you want to select a specific transmission rate, select one that the AP or peer
If you want to select a specific transmission rate, select one that the AP or peer
wireless device supports.
Note: With USB1.0/1.1, the G-210H can only transmit at up to
11Mbps.
Wireless Mode
Select the wireless mode you wish to have the G-210H
transmit in. Available
options are to be transmitting in 802.11B/G Mixed mode which will
alternate between 802.11B and 802.11G depending on the network
environment, or 802.11B Only which will force the
G-210H to broadcast in
802.11B network only.
11B/G Protection
The factory default setting is on Auto which is the most efficient and will allow your
G-210H to automatically configure the network settings to best navigate through
interfering networks.
Enable Tx Burst
Transmission bursting is a method that can boost performance by pushing high
number of frames of data per transmission packet. Check this box to enable this
feature.
Fast Roaming at
Fast Roaming is a feature that allows your G-210H to search for Access Points
while you’re moving at a faster rate. Select at which dBm you wish for this feature
to activate with the drop down menu
Enable WMM
WMM is the WiFi standard for wireless Quality of Service. Click on this button and
then select from the two available check boxes Direct Link and WMM-Power
Save Enable.
Save
Click Save to save the changes to the G-210H.