Kiddesigns Inc BE278 User Manual

1.  Turn on the VCR, BE-278 base unit and the camera. The green LEDs on the base and camera will

be turned on. Put in a blank videotape into your VCR.

2.  To start recording, press the REC button on the VCR or using your VCR remote controller.
3.  To pause it, just press the PAUSE button on your VCR or using your VCR remote controller.
4.  To continue the recording, just press the PAUSE button again or REC button which depend on

your VCR operation.

5.  After complete recording, just presses the STOP button on the camera then turn it off.
NOTE: Depending on the brand of VCR you are using, it may have difference operation for pause and
re-recoding operation. Please read your VCR operation manual carefully and follow steps base on it.

1.  Revise your tape to the beginning recording location.
2.  Press Play Button to review your recorder images.

1.  External MIC – The unit also came with a wired external MIC so you can plug it into the MIC jack

that locate in front of camera to pick up sound more clarity.

2.  Tri port – For you to fix the camera so you can take your picture by yourself.

Cleaning the Cabinet
Take cares to keep the unit clean and dry. You may clean the cabinet with mild soap and water.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

Caution:
The changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.