Proxim HRFUSB2 User Manual
51
If the Symphony HomeRF adapter is listed in the Device Manager’s Network
Adapters category and has an “!” next to its entry, refer to the section entitled
“Adapter Does Not Install” for instructions.
Adapters category and has an “!” next to its entry, refer to the section entitled
“Adapter Does Not Install” for instructions.
If the Symphony HomeRF adapter does not appear in the Device Manager’s
Network Adapters category, check the Other Devices category for a Proxim
device, a HomeRF device or an entry that reads, IMPORTANT! Run Setup
from the Symphony CD. If any of these entries exist in the Other Devices
category, run SETUP.EXE from the Symphony Installation CD to begin the
installation of the Symphony HomeRF adapter.
Network Adapters category, check the Other Devices category for a Proxim
device, a HomeRF device or an entry that reads, IMPORTANT! Run Setup
from the Symphony CD. If any of these entries exist in the Other Devices
category, run SETUP.EXE from the Symphony Installation CD to begin the
installation of the Symphony HomeRF adapter.
Adapter Does Not Install
If an error message appears that the Symphony HomeRF adapter is not
installed properly, then one of the following most likely occurred:
installed properly, then one of the following most likely occurred:
❑
The installation failed to copy all or some of the Windows network-
ing files
ing files
❑
The Symphony HomeRF adapter encountered a resource conflict
with another device in the computer
with another device in the computer
Follow these steps to determine if the adapter is working properly:
1.
Open the Device Manager and look for a Symphony HomeRF entry in the
Network Adapters category.
Network Adapters category.
2.
If the entry does not exist, confirm that the adapter is plugged in and refer
to the “Symphony Composer Does Not Start” section for additional sug-
gestions.
to the “Symphony Composer Does Not Start” section for additional sug-
gestions.
3.
If the entry exists and has an “!” next to it, right-click the Symphony
HomeRF entry and select Properties from the drop-down menu.
HomeRF entry and select Properties from the drop-down menu.
4.
Click the Resources tab (if applicable) to see what system resources, if
any, are in use by the Symphony HomeRF adapter.
any, are in use by the Symphony HomeRF adapter.
5.
If the card has failed to load or has been assigned no resources, then there
was an error during installation (for example, you may have directed the
installation wizard to skip a file that it needed to properly install the
adapter). Run the Symphony Uninstall program to begin the installation
procedure again. See Chapter 8 for details.
was an error during installation (for example, you may have directed the
installation wizard to skip a file that it needed to properly install the
adapter). Run the Symphony Uninstall program to begin the installation
procedure again. See Chapter 8 for details.