Davis Instruments DWW6320 User Manual
Setting the Transmitter ID
Page 5
Setting Console/Receiver(s) to Same ID
1. Put your console into Setup Mode — press and hold the DONE key and press the
DOWN arrow key.
The console will show you Screen 1: Transmitters. You should see the words:
“RECEIVING FROM...” and “STATION NO.” followed by the transmitter
IDs that your console detects. One of these should be the ID number you just
set on the temperature station transmitter. If you don’t see it, make sure the
console is within 10' of the transmitter, and verify that you set the dip-
switches correctly. If you still don’t see it, go to “Put the transmitter in TEST
mode” below.
“RECEIVING FROM...” and “STATION NO.” followed by the transmitter
IDs that your console detects. One of these should be the ID number you just
set on the temperature station transmitter. If you don’t see it, make sure the
console is within 10' of the transmitter, and verify that you set the dip-
switches correctly. If you still don’t see it, go to “Put the transmitter in TEST
mode” below.
2. Press the DONE key to move on to Screen 2: Selecting Transmitters.
Setup Mode – Screen 2 is where you will set the console to recognize signals
on that ID as coming from a temperature station.
on that ID as coming from a temperature station.
3. Press the LEFT or RIGHT arrow key, or the STATION key, to scroll through transmitter
IDs.
When you see the ID you chose for the temperature station, use the UP or
DOWN arrow keys to activate reception of that ID code. Make sure the
screen shows “ON”.
DOWN arrow keys to activate reception of that ID code. Make sure the
screen shows “ON”.
4. Press the GRAPH key to change the type of station assigned to that transmitter ID.
Press the GRAPH key until the word “TEMP” appears.
5. To exit Setup Mode, press and hold the DONE key.
(See the
Vantage Pro User’s Manual & Setup Guide
: “Setup Mode – Screen 2:
Selecting Transmitters.”)
Viewing Current Temperature
Press the TEMP key until you see an ‘outside’ temperature displayed on the
console screen, with the correct Station No. displayed above or below it. This
confirms communication between your temperature station and the console —
go on to “Choosing a Location for the Wireless Temperature Station” on page 6.
console screen, with the correct Station No. displayed above or below it. This
confirms communication between your temperature station and the console —
go on to “Choosing a Location for the Wireless Temperature Station” on page 6.
If You Do Not See Current Values from the Correct Station No.
First, verify that the console/receiver is powered and is not in Setup Mode (exit
Setup Mode by pressing DONE key and holding it for a moment). Then, on the
temperature station, check that the battery is properly installed. Walk around
the room with the console, standing for a few moments in various locations to
see if you are picking up signals.
Setup Mode by pressing DONE key and holding it for a moment). Then, on the
temperature station, check that the battery is properly installed. Walk around
the room with the console, standing for a few moments in various locations to
see if you are picking up signals.
Wireless Temp Page 5 Thursday, November 30, 2000 9:55 AM