Indyme Solutions Inc CB529A User Manual

Page of 5
Technical Document 
CB529A Program & Install Instructions                                5                                                              P/N 430721-00 Rev C 
 
FCC Notice of Compliance  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.  
The user is cautioned that changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate this equipment. 
This device complies with Industry Canada licence-exempt RSS standard(s). Le présent appareil est 
conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est 
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur 
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en 
compromettre le fonctionnement. 
Class B statement: 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 
one or more of the following measures: 
—Reorient or relocate the receiving antenna. 
—Increase the separation between the equipment and receiver. 
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
—Consult the dealer or an experienced radio/TV technician for help. 
PRE-RELEASE