Lutron Electronics Company Inc 0021 User Manual
2
Battery Installation (-C Models)
1.
Remove battery cover.
2.
Install batteries as shown. Use two, 1.5V AAA
Alkaline batteries only.
Alkaline batteries only.
3.
Replace battery cover.
DC Adapter Installation (All Models)
1.
Find a suitable location for the RF Tabletop
Keypad. Place the Keypad in a convenient and
accessible location. Note: RF Keypads should be
located within 30 feet of an RF Signal Repeater or
an RF Processor.
Keypad. Place the Keypad in a convenient and
accessible location. Note: RF Keypads should be
located within 30 feet of an RF Signal Repeater or
an RF Processor.
2.
Apply power to the RF Tabletop Keypad.
If the LEDs do not flash when powered,
ensure that the DC adapter is installed
properly and that there is power at the
receptacle. If problem persists, call the
Lutron Technical Support Center at (800)
523-9466.
ensure that the DC adapter is installed
properly and that there is power at the
receptacle. If problem persists, call the
Lutron Technical Support Center at (800)
523-9466.
?
Optional Wall Mounting
RF Tabletop Keypads may be wall mounted using the
supplied wall bracket.
supplied wall bracket.
Verify LEDs
flash when pow-
ered
flash when pow-
ered
Plug in power
cord and DC
adapter
cord and DC
adapter
Attach wall bracket to wall using the
supplied screws and wall anchors.
supplied screws and wall anchors.
Wrap excess DC Adapter cord (if
using) around the cord holder.
Align Keypad and snap onto
wall bracket.
using) around the cord holder.
Align Keypad and snap onto
wall bracket.
Note: (Battery-operated models
only)
• The RF Tabletop Keypad goes to “sleep”
after a short period of inactivity.
• Press any button to “wake up” the
Keypad.