KAPSCH TRAFFICCOM CANADA INC. 802295 User Manual

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential

360450-210: A7

Page 232 of 282

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: UM 360450-210 OPERATIONS AND MAINTENANCE MANUAL.DOCX

10/31/2013 7:56

Kapsch TrafficCom

Note: Ensure that the new firmware version is more recent than the active firmware version

2. Check the

Space remaining to ensure there is enough Reader memory to load the new firmware.

3. If there is not enough Reader memory, delete an older, inactive version of the firmware (see Deleting

firmware, page 235).

4. Click the

Browse button to select the new firmware file saved on the computer.

5. Click the

Upload and Verify Software Update button, then click Yes to confirm.

Result: The firmware will upload from the computer to the Reader. After the firmware has finished uploading

to the Reader, the firmware appears in the table of available firmware versions as INACTIVE.

To begin using the new firmware, activate the firmware (see Activating new firmware, ).

Activating new firmware

The currently active firmware version becomes inactive once another firmware version is activated. All

numbered callouts in parenthesis refer to Figure 7-2.
The following procedures outline the steps for activating an inactive firmware version stored on the

Reader.
Prerequisites: You must have

Software Management permissions.

The primary and secondary sides of the Reader are running normally.
The required firmware is uploaded to the Reader (see New firmware , page 231).