Hughes Network Systems 24HX-001 User Manual
1027145 – 0001 Revision E
Installing ODUs 4–23
Hub installation
Follow these steps to attach the transceiver to the antenna:
1.
Remove the plastic plug from the antenna waveguide and
the plastic cap from the transceiver coupling.
the plastic cap from the transceiver coupling.
CAUTION
Always keep the waveguide and coupling
plugs in place when the transceiver is
detached from the antenna, to prevent
contamination.
plugs in place when the transceiver is
detached from the antenna, to prevent
contamination.
2.
Position the transceiver so the three connectors point
downward and its four mounting bolts are aligned with the
four grooves on the antenna bracket, as shown in figure
4-19.
downward and its four mounting bolts are aligned with the
four grooves on the antenna bracket, as shown in figure
4-19.
T0006037
Transceiver
Antenna bracket (between
antenna and transceiver)
antenna and transceiver)
Waveguide
Antenna
Some antenna models may be
smaller than the antenna shown here.
smaller than the antenna shown here.
Groove and
mounting bolt.
mounting bolt.
(Bolts are attached
to transceiver.)
to transceiver.)
Connectors
Figure 4-19
Aligning the transceiver mounting bolts
4.10
Attaching the
transceiver to the
antenna
transceiver to the
antenna