Yaesu Musen Co. Ltd. 30143X3D User Manual
GX3000S
Page 58
11.9 MANUAL INPUTTING OF THE GPS LOCATION (LAT/LON)
You may send the Latitude/Longitude of your vessel manually even if the
GX3000S is not connected the GPS receiver unit.
GX3000S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
Position Send will contain the manually entered position.
1. Press and hold down the [CALL(MENU)] key until
“
Radio Setup
” menu appears.
2. Turn the CHANNEL selector knob to select “
DSC
Setup
” menu.
3. Press the [ENT] key, then select “
POS Input
” with
the CHANNEL selector knob.
4. Press the [ENT] key. The transceiver will beep, and
the display will be as shown in the illustration on the
right.
right.
5. Enter the your local time by the 24-hour system on
the UTC time. Use the [ENT] and [H/L(NAV)] key to
navigate to each column of the time, then use the
CHANNEL selector knob to select the desired num-
bers in each colum. Repeat for each column, to com-
plete the time.
navigate to each column of the time, then use the
CHANNEL selector knob to select the desired num-
bers in each colum. Repeat for each column, to com-
plete the time.
6. Enter the Latitude/Longitude of your vessel location
with the same procedure as description above.
7. To store the data entered, press the [ENT] key. To
exit this menu and return to radio mode press the
[16/9] key.
[16/9] key.
FCC ID: K6630143X3D/IC ID: 511B-30143X3D
Vertex Standard Co., Ltd.