EMS Technologies Canada Ltd. HSD-128 User Manual
Page 2–30
18 September 2007
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
1.
Connect to the HSD-128 Maintenance Port.
2.
Type the password maint
3.
In Menu 3, press P.
4.
Follow the application prompts and enter the LES access codes for each
Ocean Region as provided by your service provider. A valid LES ID (LES
Access Code) must be entered for all Ocean Regions. A valid LES ID number
must also be entered for the Secondary LES parameter; the same LES
Access Code as the Primary LES Access Code must be used.
Ocean Region as provided by your service provider. A valid LES ID (LES
Access Code) must be entered for all Ocean Regions. A valid LES ID number
must also be entered for the Secondary LES parameter; the same LES
Access Code as the Primary LES Access Code must be used.
Note:
Although at the time of writing the Inmarsat LES have not yet
implemented the recognition the Secondary LES Access Code
parameter in their systems, the HSD requires that a valid LES Access
Code for the Secondary LES is entered in the configuration.
implemented the recognition the Secondary LES Access Code
parameter in their systems, the HSD requires that a valid LES Access
Code for the Secondary LES is entered in the configuration.
5.
Using the “Console Mode” function in Menu 18, access each HSD-X installed
on the system and configure the LES access codes as described above.
on the system and configure the LES access codes as described above.
CAUTION:
Do not change the Satellite Longitude parameter—press Enter
to continue.
(g) Changing LES access codes using control processor software version 7.0 (or
later)
To change all of the LES Access Codes simultaneously to the same LES Access
Code—available in systems operating software version 7.0 or later:
To change all of the LES Access Codes simultaneously to the same LES Access
Code—available in systems operating software version 7.0 or later:
1.
Connect to the HSD-128 Maintenance Port.
2.
Type the password maint.
3.
In Menu 3, press I.
4.
Follow the application prompts and enter the LES access code. The Menu
3, I command configures the Primary and Secondary LES Access Codes for
all of the Ocean Regions to the same LES Access Code.
3, I command configures the Primary and Secondary LES Access Codes for
all of the Ocean Regions to the same LES Access Code.
Note:
In cases where the Service Provider requires different LES Access
Codes for different Ocean Regions, each LES Access Code must be
programmed individually using Menu 3, item P.
Codes for different Ocean Regions, each LES Access Code must be
programmed individually using Menu 3, item P.
5.
Using the “Console Mode” function in Menu 18, access each HSD-X installed
on the system and configure the LES access codes as described above.
on the system and configure the LES access codes as described above.
E. Removing the LED Label
A label covers the LES Access Codes LEDs. You can remove this label once you have
configured the LES Access Codes.
configured the LES Access Codes.
F. Activating Configurations
After configuring the HSD system parameters, the HSD and HSD-X transceivers must be
reset using one of the following methods:
reset using one of the following methods:
•
In Menu 2, press Z to reset the system;
•
Cycle the power to the HSD, and if applicable, HSD-X transceiver(s); or,