EMS Technologies Canada Ltd. HSD-MK2 User Manual
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30
3-14
3 JUN 10
•
IRS#1 A TP4J
•
IRS#1 B TP4K
•
IRS#2 A TP5C*
•
IRS#2 B TP5E*
You can configure IRS#2 as a secondary IRS bus, or an input bus for the
AES ID.
AES ID.
(b) Antenna Interface
The ARINC 741 antenna subsystem BSU is connected to the HSD-440 Mark 2
Terminal as specified in Table 3-11.
Terminal as specified in Table 3-11.
Table 3-11 HSD-440 Mark 2 Terminal to BSU Interconnects
Signal Name
Signal Source
Signal
Destination
HSD-440 Mark
2 Terminal
Mechanical
HGA
Phased-Array or
Conformal HGA
HPA MUTE A
Top/Port BSU-G
TP3A
STBD BSU-G
TP3C
HPA MUTE B
Top/Port BSU-H
TP3B
STBD BSU-H
TP3D
BSU BITE A
BSU-W(G)*
Port BSU-W
TP2A
STBD BSU-W
TP2C
BSU BITE B
BSU-X(H)
Port BSU-X
TP2B
STBD BSU-X
TP2D
Multi-Control A
TP3E
BSU-T(A)
Multi-Control B
TP3F
BSU-U(B)
*Letters in (brackets) represent EMS Aviation AMT-50 BSU pin designations
Top/Port (T/P):
Refers to Mechanical (fin-mount) HGA Subsystem
Port:
Refers to Phased Array (Fuselage-mount) or Port side of Dual (side)
Conformal-mount, HGA subsystem
Conformal-mount, HGA subsystem
Starboard (STBD):
Refers to starboard side of Dual (side) Conformal-mount HGA subsystem
NOTE:
If a third MCDU is installed, the HSD-440 cannot use the side mount
antennas because the input is allocated to either the third MCDU or the
starboard BSU Bite.
antennas because the input is allocated to either the third MCDU or the
starboard BSU Bite.