Digital Security Controls Ltd. 005132XS433 User Manual

10

It is very important to test the proposed placement of each wireless device before
it is mounted. Following these steps will test the signal strength between the PC5132-
433 and the wireless devices.

You can test all of the devices together (global placement testing) or test each device
individually. To test all the devices together, see 

Testing All Wireless Devices

Together. To test wireless devices individually, see Testing Individual Devices.

NOTE: After you have enrolled the wireless devices, you must exit and then re-
enter installer’s mode at least once before you can perform a placement test.

Testing All Wireless Devices Together:
1. Temporarily put the wireless devices in the places you want to mount them.
2. At a system keypad, enter [

✱][8][Installer’s Code].

3. Enable the Global Module Placement test by entering section [804].

Then enter sub-section [90] and turn on option [8].

4. Press [#] twice.
5. Enter programming section [904], then enter [01].
6. Activate one of the devices being tested until a result is displayed on the

keypad or sounded by the keypad or bell:

WLS904-433/WLS904P:     To perform a Placement Test on the WLS904-433,
remove the detector from the back plate and then replace it. Once the detector
is replaced on the backplate the LED on the detector will flash rapidly 5 times to
indicate that it has sent a transmission. The panel will show and/or sound the
result of the placement test on the keypad. To perform a 2

nd

 and 3

rd

 test, repeat

this procedure. 

Carefully replace the backplate onto the detector, ensuring

Carefully replace the backplate onto the detector, ensuring

Carefully replace the backplate onto the detector, ensuring

Carefully replace the backplate onto the detector, ensuring

Carefully replace the backplate onto the detector, ensuring

that “TOP”

that “TOP”

that “TOP”

that “TOP”

that “TOP”

 is facing upward, or you may damage the tamper switch.

 is facing upward, or you may damage the tamper switch.

 is facing upward, or you may damage the tamper switch.

 is facing upward, or you may damage the tamper switch.

 is facing upward, or you may damage the tamper switch.

NOTE: When you remove the detector from the backplate (tamper the unit), the
detector will also be put into “Detector Walk Test” mode. While in Walk Test Mode
the detector will activate the LED when motion is detected. The detector will also
send a signal to the receiver 5 seconds after motion is detected, indicated by 5
rapid flashes by the LED. The LED will only work in this fashion for 10 motion
detections after a tamper/restore. Note, that the panel will ignore these transmis-
sion signals with respect to a placement test. The only way in which the panel will
acknowledge a placement test, is if the backplate has, each time, been removed
and restored.

WLS906-433: Remove the detector from its backplate, wait 5 seconds and
reattach it, or hold a magnet near the raised line on the outer rim, then remove it.
WLS907-433/WLS925L-433: Open the contact by moving the magnet away
from the unit. The keypad will show/sound the test result. After the first test
result has been generated (about 10 seconds) close the contact to
generate another test result. If the unit is attached to a door or a window,
open and close the door or window to activate the device.

WLS909-433/WLS919-433: Press any function key at several different locations.
WLS912L-433:     Press and hold the test mode tab for 5 seconds. Release
the test mode tab.

Testing & Mounting