Digital Security Controls Ltd. 01NB5132 User Manual

5

For wireless keys to work on the system, you need to enroll them and then program
the function buttons. Wireless keys are not assigned to zones and require no zone
programming. You can enroll up to 16 wireless keys on the system.

Enroll Wireless keys
1. At a system keypad, enter [✱][8][Installer’s code] to go to the Installer’s

Programming section.

2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to assign the wireless key a slot. These

numbers correspond to wireless key numbers 01-16.

4. Enter the key’s ESN. The entry 

must be six digits. If an older key with a

5-digit ESN is being enrolled, add the digit [0] to the beginning of the
ESN. (E.g. ESN=61234, enter 061234)

5. The key is now enrolled on the system. Record the serial number and

the assigned slot number in the programming worksheets in the back of
this manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.
7. (PC501

(PC501

(PC501

(PC501

(PC501X

X

X

X

X only)

 only)

 only)

 only)

 only) By default, all wireless keys are assigned to Partition 1.

To assign keys to Partition 2, enable the appropriate options in
programming sections [91] and [92].

NOTE: A wireless key can only be assigned to one partition.

8. To exit press [#].

Program the WLS909-433 Function Buttons
WLS909-433 wireless keys have four programmable function buttons. You must
program a set of four functions for the buttons before any keys will work. After
the functions are programmed, when you press and hold one of the four buttons
for two seconds, the system will execute the programmed function.

 program the function buttons in section

[59]. All wireless keys will have the same four functions.

 all wireless keys assigned to

Partition 1 will have the four functions programmed in section [59]. All wireless
keys assigned to Partition 2 will have the four functions programmed in section
[60]. For example, if function button 1 in Section [59] is programmed for Stay
arming, then pressing the first button on wireless keys assigned to Partition 1 will
Stay arm Partition 1.

NOTE: Wireless keys will not work when the partition they are assigned to is
being accessed for zone bypassing or programming.

1. At a system keypad, enter [✱][8][Installer’s code].
2. Enter programming section [804].
3. Enter programming section [59] for keys assigned to partition 1, or [60]

for keys assigned to partition 2.

4. For each of the 4 function buttons, enter the 2-digit number of the

function you want to select. See the programming worksheets in the back
of this manual for a list of function key options.