Digital Security Controls Ltd. 05RF5501NA User Manual
14
O T H E R P R O G R A M M I N G
To turn OFF jamming signal detection:
1. Enter [
✱][8][Installer Code] to enter Installer Programming.
2. Enter [804] to enter the PC5132 Module Programming.
3.
Turn ON section [90], option [7].
4. To exit press [#].
The RF5501-433 can also be programmed to indicate the jamming trouble condition
with the RF Jam Zone. For RF Jam Zone to work, you must select an unused zone to
be used as the RF Jam Detect zone. When the receiver detects an attempt to jam the
RF signal, the RF Jam Detect zone will be violated and the system will generate a
tamper signal. When the jamming signal is gone, the RF Jam Detect zone closes and
the system sends a tamper restore signal.
with the RF Jam Zone. For RF Jam Zone to work, you must select an unused zone to
be used as the RF Jam Detect zone. When the receiver detects an attempt to jam the
RF signal, the RF Jam Detect zone will be violated and the system will generate a
tamper signal. When the jamming signal is gone, the RF Jam Detect zone closes and
the system sends a tamper restore signal.
T
T
T
T
To enable RF jamming detection:
o enable RF jamming detection:
o enable RF jamming detection:
o enable RF jamming detection:
o enable RF jamming detection:
1. Enter [*] [8] [Installer's Code].
2. Enter programming section [804].
3. Enter section [93]. Enter the 2-digit number of the RF Jam Detect zone ([01] to [32])
in the programming section.
4. Disable supervision for the RF Jam detect zone by turning the relevant option off in
section [82], [83], [84] or [85]. (See section 4.3 for more information.)
5. RF jamming detection is now enabled. To exit Installer programming, press [#].
NOTE: A jamming condition will be indicated as RF Jam Zone if section [93] is pro-
grammed, regardless of the RF Jam indicates Trouble option (section [90], option [7]).
grammed, regardless of the RF Jam indicates Trouble option (section [90], option [7]).
4.5 Receiver Software Default
Returning the receiver programming to factory default settings is a quick way to remove
all the enrolled devices from the system and reset all the programming in section [804].
all the enrolled devices from the system and reset all the programming in section [804].
NOTE: Performing this procedure will not change any programming sections except
[804]. Resetting the control panel to factory default settings will not return the RF5501-433
to factory default settings.
[804]. Resetting the control panel to factory default settings will not return the RF5501-433
to factory default settings.
To restore the PC5132 portion of the RF5501-433 programming to the factory default
settings, perform the following:
settings, perform the following:
1. Enter [
✱][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. Press [#]. The software for the
receiver section will be restored to its factory default settings.
For instructions on restoring the default programming of the control panel or any other
connected module, see your system
connected module, see your system
Installation Manual.
4.6 Keypad Software Default
To restore the keypad defaults, perform the following:
1. Enter [
✱][8] [Installer’s Code].
2. Press [
✱][99][✱].
NOTE: This does not affect the PC5132 portion of the keypad.
O T H E R P R O G R A M M I N G