Digital Security Controls Ltd. 05SKY User Manual

11

• Remove the circular knockout in the top left corner of the

control panel cabinet. Mount the Skyroute unit in its place.

• Secure the Skyroute module to the cabinet using the supplied

screws.

• Attach the Skyroute antenna to the unit.
• Disconnect and remove the AC and battery power from the

control panel. Wire the red, black, yellow and green wires
from the panel Keybus to the corresponding RED, BLK,
YEL and GRN terminals on the Skyroute transceiver.

• Wire a normally closed tamper switch between the COM and

TAM terminals of the Skyroute module. If a tamper switch is
not going to be used, place a jumper wire between the COM
and TAM terminals.

• Wire the BELL+ terminal of the panel to the  BELL IN ter-

minal of the Skyroute unit. The wire run must not exceed
150 ft. / 45.5 m.

• Wire the BELL- terminal of the panel to the negative (-) ter-

minal of the bell/siren.

• Wire the BELL+/SIREN+ terminal of the bell/siren to the

BELL OUT terminal of the Skyroute transceiver.

• Apply AC and DC power to the control panel. Power up both

the Skyroute module and the panel.

• Do the programming if it is required.
• Call the Connect 24 VRU (Voice Reponse Unit) to activate

your Skyroute account.

Power Requirements
The PC5204 power supply requires a 16V, 40 VA transformer
and a 12V, 7 Ah battery.

Connections
• The Keybus from the panel is connected to both the PC5204

module and the Skyroute transceiver.

• A wire is connected from the AUX terminal on the PC5204

module to the BELL IN of the Skyroute transceiver.

• A jumper or a normally closed switch is required between

the TAM and the COM terminals on the Skyroute trans-
ceiver.

• A jumper or a normally closed switch is required between

the TAM and the BLK terminals for the tamper of the
PC5204 power supply.

• Wire the positive lead of the device to the AUX+ terminal.
• Connect a 1000 Ohm resistor between AUX+ and O1 termi-

nals.