Digital Security Controls Ltd. 06GS30551 User Manual
7
ACTIVATING THE OUTPUTS
T
his Device has 4 OC outputs programmable as Automatic (outputs with this attribute will activate in response to the
associated events) or Remote Control (outputs with this attribute can be activated manually from remote locations by
means of SMS messages or calls from enabled telephone numbers.
means of SMS messages or calls from enabled telephone numbers.
Activating/Deactivating Automatic Outputs
The OC outputs can be activated automatically by the following events:
Land line trouble (line down)
GSM Module trouble
GSM trouble (Limited/No Service)
Power supply trouble
Incoming call
Outgoing call
ContactID digital report
Enablement of remote programming
,
,
,
,
,
Once an OC output has been activated automatically, it will not restore to standby until all the causes of
activation clear.
activation clear.
Activating/Deactivating Remote-control Outputs
The OC outputs can be programmed as BISTABLE (activated/deactivated by means of an SMS text message or Remote
Control number) or MONOSTABLE (activated by means of SMS text messages or Remote Control numbers). Once
a Monostable output has been activated, it will not deactivate until the programmed ON Time expires. Each output can be
set up to provide a feedback signal (ring or SMS text message).
Control number) or MONOSTABLE (activated by means of SMS text messages or Remote Control numbers). Once
a Monostable output has been activated, it will not deactivate until the programmed ON Time expires. Each output can be
set up to provide a feedback signal (ring or SMS text message).
,
,
,
,
,
For further information regarding the terms “Access Code” and “Output Label” (used in the following
section), refer to the “Outputs Page” in the “Software” section.
section), refer to the “Outputs Page” in the “Software” section.
Bistable Outputs (for appliance management)
Bistable OC outputs can be activated in 2 ways.
1. By sending a case sensitive SMS text message containing the respective Access Code, placed between pound signs
1. By sending a case sensitive SMS text message containing the respective Access Code, placed between pound signs
(#), and the Output Label (e.g. GATE) followed by =ON, as follows:
#ACCESSCODE#OUTPUTLABEL=ON (example: #AZ55#GATE=ON)
2. By sending a cost-free call from a preset Remote Control number. This Device will activate the respective output
without answering the call.
,
,
,
,
,
Bistable OC outputs can be deactivated by sending a case sensitive SMS text message containing the respective
Access Code placed between pound (#) signs and Output Label (e.g. GATE) followed by =OFF, as follows:
Access Code placed between pound (#) signs and Output Label (e.g. GATE) followed by =OFF, as follows:
#ACCESSCODE#OUTPUTLABEL=OFF (example: #AZ55#GATE=OFF)
The SIM-CARD can be programmed via PC, using the GS3050 Software Application or via any GSM Cellphone or in "C-24
Monostable Outputs (for appliance management)
Monostable OC outputs can be activated in 2 ways.
1. By sending a case sensitive SMS text message containing the respective Access Code placed between pound (#) signs
1. By sending a case sensitive SMS text message containing the respective Access Code placed between pound (#) signs
and Output Label followed by “=ON” or “=OFF”, as follows:
#ACCESSCODE#OUTPUTLABEL=ON
#ACCESSCODE#OUTPUTLABEL=OFF
2. By sending a cost-free call from a preset Remote Control number. This Device will activate the output concerned
without answering the call.
,
,
,
,
,
Monostable OC outputs deactivate (switch OFF) automatically when the programmed ON Time expires
Programming the Device
,
,
,
,
,
If this Device is to manage all the SMS functions, use a 32 K SIM CARD (or higher) which holds at least 20
text messages.
text messages.