Digital Security Controls Ltd. 07GS3060 User Manual

INSTALLING THE GS3060

CONNECT 24 Enrollment Information

Only authorized dealers can enroll a GS3060 with CONNECT 24. Dealer application forms and
additional information on the CONNECT 24 Voice Response Unit can be found at the CONNECT 24
web site www

www

www.connect24.com

.connect24.com

.connect24.com. Please contact CONNECT 24 at the number below for assistance:

USA 1-888-251-7458

CANADA 1-888-955-5583

NOTE: Steps 1 and 2 should be completed before powering the GS3060 unit.

STEP 1 - Activate Your SIM Card

Your SIM card must be activated with Connect 24 prior to use. Please call the Voice Response
Unit (VRU) at least 24 hours prior to installation.

STEP 2 - Initialize the GS3060 with Connect 24

Call the VRU at the toll-free number. Follow the voice prompts and enter in your profile number,
installer ID number, installer PIN number and central station number. Ensure all information is available
before calling the VRU. All this information can be found in your VRU Enrollment Package.

STEP 3 - Determine Best Signal Location

1. Remove the screw and the front cover [1].
2. Fit the antenna [2] (ensure that the bolt [3] is fastened tightly).
3. Using the connector [5], connect the GSM Module [17]. Ensure the connector is secure.

NOTE: Before inserting or removing the SIM card, please ensure the unit is powered down.

4. Power up the GS3060 and check signal strength.

• Connect battery to the RED and BLK battery leads.
• Connect DC Power source to +/- 12V terminals.
• Allow unit to power up
• The green LEDs will indicate the signal strength. The bottom green LED must be ON for the
location to be acceptable. Please refer to the “Status LEDs” section for more information.

5. Power down the GS3060 by removing the DC power source and battery leads.

STEP 4 - Connect the GS3060

1. Using the cabinet, mark the 4 screw locations then drill the anchor screw holes.

NOTE: Check for cable conduits and water pipes before drilling.

2. Using anchor screws (not included), mount the cabinet to the wall.
3. Run the cables, then pull them through the cable entry [14] or the knockouts provided.
4. Complete the connections on the terminal board [12].

Ensure power and Telco circuit con-

nections are made only after the cabinet has been secured to the building or structure
and has been connected to the protective earth ground. Descriptions of the terminals can
be found in the “Connecting the GS3060” section.

5. Using the 4 screws, reattach the front cover [1] securely to the cabinet.

NOTE: Please refer to Figure 2 at the end of this manual for wiring diagram.