Digital Security Controls Ltd. 13WTK5504P User Manual
5
• The system returns to the Home screen and the red Armed indicator turns OFF.
• The alarm status is momentarily displayed in the status bar and the voice prompt announces
• The alarm status is momentarily displayed in the status bar and the voice prompt announces
“System disarmed”.
• The green Ready indicator turns ON.
Away Arm
Home > Away Arm
When Away Arm is selected from the Home screen
Home > Away Arm
When Away Arm is selected from the Home screen
• “Exit delay in progress” is displayed in the Status Bar. The pre-programmed exit delay begins.
• The voice prompt announces “Away arming in progress,” followed by “please exit now”.
• The touchscreen “beeps” at a 1-second urgency interval during the exit delay, then double-beeps
• The voice prompt announces “Away arming in progress,” followed by “please exit now”.
• The touchscreen “beeps” at a 1-second urgency interval during the exit delay, then double-beeps
for the last 10 seconds.
If Disarm is selected during the exit delay
• A numeric keypad is displayed. Tap your access code.
• The Arming sequence is aborted and the system returns to the Home screen.
• The Armed LED turns OFF.
• The Arming sequence is aborted and the system returns to the Home screen.
• The Armed LED turns OFF.
At the end of the pre-programmed exit delay:
• The Home screen is displayed, indicating that the system is armed
• The Ready Indicator turns OFF.
• “Away Armed” is displayed in the Status Bar.
• The Ready Indicator turns OFF.
• “Away Armed” is displayed in the Status Bar.
Bell/Siren Sounds After Away Arming
Audible Exit Fault
In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper exit
Audible Exit Fault
In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper exit
when arming the system in the Away mode. In the event that you fail to exit the premises during the
allotted exit delay period, or if you do not securely close the Exit/Entry door, the system will notify you
that it was improperly armed in two ways: the keypad will emit one continuous beep and the bell or
siren will sound.
Your installer will tell you if this feature has been enabled on your system. If this occurs
1. Re-enter the premises.
2. Enter your access code to disarm the system. You must do this before the entry delay timer
2. Enter your access code to disarm the system. You must do this before the entry delay timer
expires.
3. Follow the Away arming procedure again, making sure to close the entry/exit door properly.
Arming Error
Arming Error
An error tone will sound if the system is unable to arm and the voice prompt will state “Failed to arm”.
This will happen if the system is not ready to arm (i.e., sensors are open) or if an incorrect user code has
been entered. A voice prompt will then state “check open zones and troubles.” If this happens, ensure
all sensors are secure. Try again, ensuring that a valid access code is entered. Please check with your
installer to determine if arming is inhibited by any other means.
Zone Status
Home > Zone Status
This screen allows you to view the status of the zones on the system. From the Home screen, press Zone
This screen allows you to view the status of the zones on the system. From the Home screen, press Zone
Status to go to the list of zones, which is displayed from Zone 1 to Zone 64. You may see closed (zones
are restored - functioning normally), open (a zone needs to be closed), or alarm statuses.