Digital Security Controls Ltd. 163G4005 User Manual

In addition to external events (decoded CID/SIA events from the panel via simulated PSTN line), the communicator will manage
following internal events.



Trigger / restore of input



Status reporting events



Mains power source failure / restore (required by EN50136-2:2013).



Battery power source failure / restore (required by EN50136-2:2013); valid only for the version with battery charger on board.



Control panel to communicator interconnection failure / restore (required by EN50136-2:2013);



Primary and Secondary Alarm Transmission Path failure / restore (Future use), (required by EN50136-2:2013);



IP receiver fault / restore;



PSTN fault / restore;



GSM fault / restore;



No Cellular network / restore;



Tampers activation / restore;



FTC fault / restore;



Periodic event.

The Installer can choose the protocol to be used (Contact ID or SIA). The chosen protocol will be used for both the triggered inputs
and the status reporting. Each input can be programmed with a specific Customer code (account). All the status reporting events
will use the same Customer code (see the following table).

The communicator will manage a queue of 32 internal events. When the queue is full, further events will be ignored. 

The priority between internal and external event will be programmable by the Installer (see par. OPTION, Priorities). 

For internal events, the timing and retry policy are managed by communicator: after the sending of a message, the device will wait
about 1 second for the receiver's ACK. The device will make up to 4 attempts to deliver a message. The events will be transmitted
to the digital receiver (see PC Programming: Communicator page).



If the DLS 5 Console has been used to program the device (see Options->Pay As You Go), it will be possible to check how much
credit is left on the pre-paid SIM CARD. If the credit balance check feature is enabled, The query of the residual credit can be done
in three ways:

1. By DLS 5 Console

.

2. By SMS command forwarding the answer to the sender number. The command sent has to include the User PIN

.

 

3. An SMS providing credit balance information (supplied by the operator) is sent to the first number in the phonebook at regular

intervals. For all operators which support credit balance requests via a network command, it will be possible to enter a
request for information using the DLS 5 Console. 

