Digital Security Controls Ltd. 163G4005 User Manual
4005 Series
21
Panel Transmission Monitoring (PTM)
The constant monitoring of communication with the control unit (PTM function) allows the Communicator to transmit calls via the
GSM network if communication between the alarm control panel and the surveillance control unit does not take place successfully
over the PSTN telephone line. If programmed (using the DLS 5 Console PTM page), this feature only works when the PSTN line
is connected to the LE terminals.
GSM network if communication between the alarm control panel and the surveillance control unit does not take place successfully
over the PSTN telephone line. If programmed (using the DLS 5 Console PTM page), this feature only works when the PSTN line
is connected to the LE terminals.
Pulse dialling detection is not supported.
The PSTN Fault event occurs when the PTM function activates.
The PSTN Fault event occurs when the PTM function activates.
The communicator will monitor the telephone line for on hook/off hook detection, once it detects an off-hook condition, it will do the
following:
following:
Detect DTMF digits dialled,
Check for a kiss-off.
The panel will not dial immediately, the minimum time between off-hook and dialling will be more than 2 seconds.
The telephone number in phonebook that have the PTM option enabled are used to determine if the call is made by the panel or house
phones. The Communicator will only monitor activity and check for kiss off when one of these number is dialled. If the option “PTM all
number” (see PC Programming->PSTN/PTM) is set than the Communicator will monitor every call made and kiss off is expected.
phones. The Communicator will only monitor activity and check for kiss off when one of these number is dialled. If the option “PTM all
number” (see PC Programming->PSTN/PTM) is set than the Communicator will monitor every call made and kiss off is expected.
Activating the Outputs
The Communicator has the Open-Collector terminals (the T1, T2, T3, T4, T5 and T6 terminals) that can be programmable as Inputs
or/and Output (max 100mA), this terminals are programmed as Outputs by default except T6 terminal programmed as Input. The
Open-Collector Outputs can be activated automatically (when certain pre-programmed events occur) or remotely, through SMS
transmission or caller identification from a number programmed previously.
or/and Output (max 100mA), this terminals are programmed as Outputs by default except T6 terminal programmed as Input. The
Open-Collector Outputs can be activated automatically (when certain pre-programmed events occur) or remotely, through SMS
transmission or caller identification from a number programmed previously.
Activating/Deactivating Automatic Outputs
The T1, T2, T3, T4,T5 and T6 Open Collector outputs can be activated automatically by the following events:
INPUT
Panel interconnection Presence: used to be connected with a panel,
Dialer Block: used to stop the dialer and delete the queue,
Force Communication On GSM: force the line switch from LE to LI.
OUTPUT
Panel Interconnection Fault: active the output if the panel is not present
Jamming Detect: active output when the device is under jamming attack.
Antenna Fault: active the output when the antenna is cut or shorted.
Tampers: when tamper is triggered.
PSTN Fault: active the output in case of PSTN fault.
GSM Fault: active the output in case of module power on fail, SIM issue, signal absent, no carrier.
No cellular Network: active the output in case of issue related to the data connection activation.
IP receiver fail: active the output in all faulty cases related to the communication with IP receiver.
Power Fault: active the output in case of power fault.
Reserved output: when this option is selected, all other events selected to activate the corresponding output are ignored.
FTC fault: if selected, the output will be activated if communication is not successful.