Digital Security Controls Ltd. 17WS9TCHW User Manual
Industry Canada Statement
The device complies with Industry Canada RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference that may cause undesired operation of the device.
and (2) this device must accept any interference that may cause undesired operation of the device.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Leprésent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio.
Exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement."
susceptible d'en compromettre le fonctionnement."
Caution
Risk of explosion if battery is replaced
by an incorrect type.
Dispose of used batteries according
to the instructions.
The device is designed and manufactured not to excede the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the United States.
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the United States.
During SAR testing, the device is set to transmit at its highest certi-
fied power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level
of the device while operating can be well below the maximum value.
This is because the device is designed to operate at multiple power
levels so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station antenna, the
lower the power output.
fied power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level
of the device while operating can be well below the maximum value.
This is because the device is designed to operate at multiple power
levels so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station antenna, the
lower the power output.
The exposure standard for wireless employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6 W/kg.
known as the Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions ac-
cepted by the FCC with the device transmitting at its highest power
level in all tested frequency bands.
cepted by the FCC with the device transmitting at its highest power
level in all tested frequency bands.
The FCC has granted an Equipment Authorization for this model
device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model device
is on file with the FCC and can be found under the Display Grant sec-
tion of www.fcc.goc/oet/ea/fccid, after searching on FCC ID:
F5317WS9TCHW.
device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model device
is on file with the FCC and can be found under the Display Grant sec-
tion of www.fcc.goc/oet/ea/fccid, after searching on FCC ID:
F5317WS9TCHW.
For this device, the highest reported SAR value for near the body is
/kg RF exposure in simulated usage near the body with 5 mm
separation.
/kg RF exposure in simulated usage near the body with 5 mm
separation.
© 2017 Tyco Security Products. All Rights Reserved. www.dsc.com
29009968R001
0.52W