TransCore 05531 User Manual
8-3
Chapter 8
Configuring the Encompass 4/4800
Multiprotocol Reader
This chapter provides instructions for configuring the Encompass
TM
4/4800 Multiprotocol Reader, including factory configuration parameter
defaults and how to use terminal emulation software to check and
change the Encompass 4/4800 Multiprotocol Reader factory
configuration defaults.
defaults and how to use terminal emulation software to check and
change the Encompass 4/4800 Multiprotocol Reader factory
configuration defaults.
Configuring the Reader
After installing the Encompass 4/4800 Multiprotocol Reader, you need to configure its
operating parameters. Terminal settings should be initially set at 9600 baud, 8 data
bits, no parity, 1 stop bit, and no flow control.
operating parameters. Terminal settings should be initially set at 9600 baud, 8 data
bits, no parity, 1 stop bit, and no flow control.
General Configuration Labeling
Each Encompass 4/4800 Multiprotocol Reader and its shipping carton are labeled to
indicate the unit’s general configuration.
indicate the unit’s general configuration.
contains explanations of the
Encompass 4/4800 Multiprotocol Reader label fields.
As an example, a label reading 4xxx-100 indicates that this Encompass 4/4800 Multi-
protocol Reader is configured with RS
protocol Reader is configured with RS
–
232 and Wiegand communications.
Default Operating Parameter Settings
Table 8-2 contains the factory default configuration settings for the Encompass 4/4800
Multiprotocol Reader operating parameters.The default configuration settings may not
be the correct operating configuration settings for a specific site. Changes to the con-
figuration settings may have to be made, depending on the site plan, as described in
Multiprotocol Reader operating parameters.The default configuration settings may not
be the correct operating configuration settings for a specific site. Changes to the con-
figuration settings may have to be made, depending on the site plan, as described in
Chapter 2 “Developing the Site Plan.
”
Table 8-1 Encompass 4/4800 Multiprotocol Reader Configuration Label Fields
Field
Description
1st
Model number
TBD
TBD
2nd
Interface
100 = RS
100 = RS
–
232 and Wiegand
101 = RS
–
422 and Wiegand
102 = RS
–
485 and Wiegand (not available
at this time)