Badger Meter Inc 2010GW User Manual
Installation & Operation Manual
Installation Procedure
NOTE: The utility is usually responsible for proper positioning of a the Transceiver. For optimum reception and
transmission, locate the Gateway in line-of-site view of the desired endpoints.
1. Unpack the Gateway Transceiver.
2. Screw a receiving antenna into each side of the Gateway (as shown in Figure 1).
3. Tighten the antennas to the full o-ring compression by hand.
2. Screw a receiving antenna into each side of the Gateway (as shown in Figure 1).
3. Tighten the antennas to the full o-ring compression by hand.
MMK Bracket Mounting
This mounting equipment is sized to mount the Gateway Transceiver on a 2-5/8-inch maximum diameter mast.
1. Open the two bags of mounting equipment.
2. Place two bolts (3/8-16 X 5 inches) through the holes in the top and bottom of the transceiver. Use the side holes for
2. Place two bolts (3/8-16 X 5 inches) through the holes in the top and bottom of the transceiver. Use the side holes for
horizontal installation.
3. Place a clamp onto the bolts.
4. Place a lock washer and nut onto each bolt.
4. Place a lock washer and nut onto each bolt.
Figure 2: Attach Hardware
5. Tighten the two nuts with a 9/16" or adjustable wrench.
(1-11)
Page 7