Badger Meter Inc 2010GW Manual De Usuario

NOTE: The utility is usually responsible for proper positioning of a the Transceiver. For optimum reception and 

transmission, locate the Gateway in line-of-site view of the desired endpoints.

1.  Unpack the Gateway Transceiver.
2.  Screw a receiving antenna into each side of the Gateway (as shown in Figure 1).
3.  Tighten the antennas to the full o-ring compression by hand.

This mounting equipment is sized to mount the Gateway Transceiver on a 2-5/8-inch maximum diameter mast.

1.  Open the two bags of mounting equipment.
2.  Place two bolts (3/8-16 X 5 inches) through the holes in the top and bottom of the transceiver. Use the side holes for 

horizontal installation.

3.  Place a clamp onto the bolts.
4.  Place a lock washer and nut onto each bolt.

5.  Tighten the two nuts with a 9/16" or adjustable wrench.

 

 (1-11)

Page 7