Code Systems Inc GMRFAB01 User Manual

 

 

 

 

525 Minnesota 
Drive 
Troy, MI 48083 

 
 

248-583-9620 
248.585.4799 
fax 
 

www.code-alarm.com 

 
 
 
 
Re: Class II Permissive Change 
for Code Systems, Inc Transceiver 
FCC ID: GOH-GMRFAB01 
IC: 3954A-RFA1 
 
 
The device under test is manufactured by the grantee (Code Systems, Inc) and sold as an OEM product. 
Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all 
applicable / appropriate operating instructions. When end-user instructions are required, as in the case of 
this product, the grantee must notify the OEM to notify the end-user. Code Systems, Inc will supply the 
following information to the reseller/distributor dictating what must be included in the end user’s manual 
for the commercial product. 
 

The following information must be included in the end product user’s manual to ensure continued 
FCC and Industry Canada regulatory compliance. The ID numbers must be included in the manual 
if the device label is not readily accessible to the end user. The compliance paragraphs below must 
be included in the user's manual. 
 
************************************************************************************* 

FCC ID: GOH-GMRFAB01  

 

IC: 3954A-RFA1 

 
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is 
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This 
device must accept any interference received, including interference that may cause undesired operation. 
 
WARNING: Changes or modifications not expressively approved by the party responsible for compliance 
could void the user's authority to operate the equipment. In addition, this device has been designed to 
operate with the antenna listed below having a maximum gain of 1.5 dB and a minimum cable loss of 1.2 
dB. Antennas and cable not included in this list or having a gain greater than 0.3 dB are strictly prohibited 
for use with this device. The required antenna impedance is 50 ohms. 
 
Xuzhou Huaxia Harness Co, PN: GM19131608, Dipole antenna with 8 ft RG174/U coax. 
Xuzhou Huaxia Harness Co, PN: GM19213158, Dipole antenna with 8 ft RG174/U coax. 
Xuzhou Huaxia Harness Co, PN: GM19213160, Dipole antenna with 8 ft RG174/U coax. 
 
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen 
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that needed for successful 
communication. 

*************************************************************************************