Code Systems Inc GMRFAB01 Manual De Usuario
525 Minnesota
Drive
Troy, MI 48083
Drive
Troy, MI 48083
248-583-9620
248.585.4799
fax
248.585.4799
fax
www.code-alarm.com
Re: Class II Permissive Change
for Code Systems, Inc Transceiver
FCC ID: GOH-GMRFAB01
IC: 3954A-RFA1
The device under test is manufactured by the grantee (Code Systems, Inc) and sold as an OEM product.
Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all
applicable / appropriate operating instructions. When end-user instructions are required, as in the case of
this product, the grantee must notify the OEM to notify the end-user. Code Systems, Inc will supply the
following information to the reseller/distributor dictating what must be included in the end user’s manual
for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information must be included in the end product user’s manual to ensure continued
FCC and Industry Canada regulatory compliance. The ID numbers must be included in the manual
if the device label is not readily accessible to the end user. The compliance paragraphs below must
be included in the user's manual.
*************************************************************************************
FCC and Industry Canada regulatory compliance. The ID numbers must be included in the manual
if the device label is not readily accessible to the end user. The compliance paragraphs below must
be included in the user's manual.
*************************************************************************************
FCC ID: GOH-GMRFAB01
IC: 3954A-RFA1
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance
could void the user's authority to operate the equipment. In addition, this device has been designed to
operate with the antenna listed below having a maximum gain of 1.5 dB and a minimum cable loss of 1.2
dB. Antennas and cable not included in this list or having a gain greater than 0.3 dB are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms.
Xuzhou Huaxia Harness Co, PN: GM19131608, Dipole antenna with 8 ft RG174/U coax.
Xuzhou Huaxia Harness Co, PN: GM19213158, Dipole antenna with 8 ft RG174/U coax.
Xuzhou Huaxia Harness Co, PN: GM19213160, Dipole antenna with 8 ft RG174/U coax.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that needed for successful
communication.
*************************************************************************************