DTC Communications Inc. PDTX250S User Manual
DTC COMMUNICATIONS, INC.
8
HEAT SINKING
When to Use a Heat Sink
The Palladium 100 does not require heat sinking in normal service. The
Palladium 250 should be attached to a heat sink or heat sinking surface if
the unit is to be installed in an enclosure, or in deployments where the
ambient temperature could exceed 50
Palladium 250 should be attached to a heat sink or heat sinking surface if
the unit is to be installed in an enclosure, or in deployments where the
ambient temperature could exceed 50
o
C.
Typical Palladium Operating Temperatures
A wide range of variables can affect the temperature of electronic devices
including ambient temperature, air flow, heat sink and mounting consider-
ations. In a typical test performed at room temperature, the Palladium
250 without a heatsink has been observed to have a baseplate operating
temperature of 40
including ambient temperature, air flow, heat sink and mounting consider-
ations. In a typical test performed at room temperature, the Palladium
250 without a heatsink has been observed to have a baseplate operating
temperature of 40
o
C (104
o
F). The Palladium 100 has been observed to
have a baseplate operating temperature of 37
o
C (99
o
F) in a similar test.
Heat Sink Installation
To install the heat sink, complete the following steps:
1. Align the transmitter and heatsink, with the back of the transmitter
mating with the front, flat surface of the heatsink.
2. Secure the heatsink with four (4) 6-32 x 1” screws. Install the screws
from the transmitter side.
3. Make sure there is good contact between the transmitter and the
heatsink. They should be mounted flush to one another.
Mounting
Screws (4)
BEST: Fins
Vertical Away
From Wall
Vertical Away
From Wall
BEST: Fins
Vertical Away
From Wall
Vertical Away
From Wall
GOOD: Fins
Vertical Away
From Wall
Vertical Away
From Wall
GOOD:
Fins Up
Fins Up
NEVER: Fins
Horizontal
Horizontal
NEVER: Fins
Down
Down