Codan Radio Communications UT-4E900 User Manual

Page of 58
MT-4E VHF & UHF Receiver & Transmitter Instruction Manual
IM08-MT-4E-TXRX-P1162
Specification Data Sheets
49
700 / 800 / 900 MHz tRanSMIttER   
PERFoRManCE SPECIFICatIonS
General
Frequency Range:
768–869 MHz, 896–960 MHz 
Carrier Frequency Stability:
± 0.1 ppm 
Channel Spacing:
12.5 and 25 kHz
Channel Selection:
6.25 kHz
Number of Channels:
Preset capability for 2 banks of 16 channels
Compatibility:
MT-3 and MT-4 Series Radio Systems; P25 interoperable*
RF Output Power:
0.5 to 3.0W Continuous
Emission Designators:
Analog: 11K0F3E (Narrow Band); 16K0F3E (Wide Band) 
Digital Paging: 9K2F1D 
P25 Digital: 8K10F1E (Digital Voice); 8K10F1D (Digital Data)*
System Impedance:
50 Ω; Type-N connector
Duty Cycle:
100%; Continuous operation
Undesired Emissions: 
(Adjacent Channel Power Ratio)
< -50 dBc, Narrow Band
< -60 dBc, Wide Band
< -67 dBc, Digital*
Undesired Emissions: 
(Conducted Spurious)
< -80 dBc @ 3.0 W RF Output 
VSWR Protection:
< 20:1 VSWR at all phase angles
Operating Temperature Range:
-30˚C to +60˚C
Operating Humidity:
95% RH (non-condensing) at +25°C
Operating Voltage:
+13.8 VDC Nominal (range +10 to +17 VDC) † 
+9.5 VDC Regulated
Transmit Current:
< 1.8A @ 3.0W RF Output 
Stand By Current:
< 115 mA (no encryption modules installed) 
< 145 mA (with encryption modules installed)
Front Panel Controls:
Transmitter Power On (Norm) / Off / Key Tx 
Mic Mode: Analog / Digital 
Analog and Digital Transmit LED indicators
PTT Time-Out-Timer:
Programmable from 15 to 465 sec. (in increments of 15 sec., ± 5 sec.) or 
infinity (default 300 sec.) using Radio Service Software.
Audio Input:
600 Ω balanced or unbalanced input  
(600 Ω or 15 k Ω selectable input impedance) 
Audio Frequency Response:
Pre-emphasis; +1, -3 dB (300 to 3000 Hz)
Audio Deviation Limiting:
± 2.5 kHz Narrow band, ± 5.0 kHz Wide band
Audio Distortion:
< 3% THD; 1 kHz tone at 1.5 kHz or 3 kHz deviation
FM Hum and Noise Ratio:
≥ 31 dB; Narrow Band Analog
≥ 37 dB; Wide Band Analog
CTCSS Decode / Encode:
Programmable to any of 42 CTCSS tones.
* P25 Digital specifications are applicable only for modules with the P25 Digital firmware upgrade.
 For GSA BPA Contract: GSC-TFMG-BPA-09-002 the following specifications apply:  
Supply Voltage range: +10 to +18 VDC