HeathCo LLC WLTX209 User Manual

 5 

HAMPTONBAY.com

 

 

Please contact 1-844-760-3644 for further assistance.

 

Ƒ Temporarily position the push button (C) where 

it will be mounted.

 

Ƒ Press the push button (C) to verify the 

doorbell (A) and push button (C) work properly. 

 

Ƒ If the doorbell (A) does not sound, move the 

doorbell (A) closer to the push button (C) and 
test again.

NOTE: Do not permanently mount the sensor or push 
buttons until the sensor, push buttons, and doorbell are all 
working properly.

In most cases, testing of the mailbox sensor requires 
two people; one person to take the sensor (B) to the 
mailbox for testing and the other to listen for the 
doorbell and watch for the “envelope” icon on the 
doorbell to light up.

 

Ƒ Temporarily position the sensor (B) next to the 

mailbox.

 

Ƒ While someone is watching and listening for the 

doorbell (A), hold the sensor (B) as shown and 
rotate to the horizontal position. The red LED on 
the sensor (B) should flash, the doorbell (A) will 
sound “Beep-Beep”, and the “envelope” icon 
will turn ON.

 

Ƒ To reset the “envelope” icon to the OFF position, 

either press and release the button on the side 
of the sensor (B) or quickly press and release 
the button on the side of the doorbell (A) twice.

 

Ƒ If the doorbell does not sound, move the 

doorbell closer to the sensor and test again.

NOTE: If the button on the side of the sensor is pressed 
to reset the “envelope” icon, there is a 10 second delay 
before the sensor will be able to re-activate the chime.

NOTE: Do not permanently mount the sensor or push 
buttons until the sensor, push buttons, and doorbell are all 
working properly.

Use either screws (BB) or double-sided tape (CC) to 
mount the push button (C).

 

Ƒ To mount with screws (BB), remove the back 

of the push button (C) by pushing in the tab on 
the bottom with a small screwdriver. Place the 
push button back on the door jamb and mark 
the two screw holes. Attach with screws (BB) 
and snap on the front of the push button (C).

 

Ƒ When attaching the push button (C) with 

double-sided tape (CC), remove paper from 
both sides of the double-sided tape (CC) and 
apply to a clean surface.

A

A

C

B

BB