HeathCo LLC WLTX209 User Manual

 

8

 

Ƒ Use a dry cloth to clean the doorbell, sensor, and push buttons.

 

Ƒ Do not use cleaners or polishes.

 

Ƒ Do not use any fluids on the doorbell, sensor, and push buttons.

Doorbell does not 
sound.

 

Ƒ Batteries not installed 

correctly.

 

Ƒ Make sure batteries are installed according to the 

diagram inside the sensor and push buttons.

 

Ƒ Batteries are dead.

 

Ƒ Check the charge of the sensor and push button batter-

ies and replace if necessary.

 

Ƒ Doorbell is not receiving 

power.

 

Ƒ Make sure the plug-in doorbell has power.

 

Ƒ The doorbell and the 

sensor or push buttons 
are not synced.

 

Ƒ Sync the doorbell to the sensor or push button(s). Only 

one sensor or push button may be synced at a time. 
Repeat these steps for each sensor or push button.

 

Ƒ Press and hold the button on the doorbell until the 

doorbell sounds a “Beep-Beep”.

 

Ƒ Press the button on the side of the sensor or the 

push button(s) within 30 seconds. The doorbell will 
sound a “Beep-Beep” tone to indicate the sensor or 
the push button(s) is synced.

 

Ƒ Rotate the sensor as shown in step 4 under Installa-

tion or press the push button(s) to ensure operation.